What is the Senergy BioTransducer CrystalWave® III?

BioTransducer Technology provides no-touch, painless therapy. The Tennant BioModulator® transmits frequencies and voltage that the Senergy BioTransducer CrystalWave® III delivers on a carrier wave into the tissue, through skin and bone. Using the Senergy BioTransducer CrystalWave® III to deliver the frequencies and voltage speeds up therapy time.

The Senergy BioTransducer CrystalWave® III is not a laser. It can be used through clothing allowing the BioModulator® therapies to be delivered anywhere on the body without the need for direct skin contact.

CrystalWave® III vs. CrystalWave® Pro

Backed by science.

The Tennant Devices have the clinical studies to prove it.

Read Clinical Studies

FAQs

What does the Senergy BioTransducer CrystalWave® III feel like?

Some users experience a subtle tingle or sensation of warmth from the Senergy BioTransducer CrystalWave® III. Most people don’t feel any sensations when using the Senergy BioTransducer CrystalWave® III You may feel initial apprehension about providing therapy to yourself or others. When you carefully follow the instructions and directions, there’s no need to be concerned. The devices and therapy steps were created with the knowledge that application will be general and does not have to be precisely aligned with any given point of the body. Even if you are providing the therapy to a different area than intended, it is not harmful and, in most cases, will still benefit you.

How do I use the Senergy BioTransducer CrystalWave® III?

INSTRUCTIONS FOR USE

1. Connect the Senergy BioTransducer CrystalWave® III to the Tennant BioModulator® with the connection wire. Use care when plugging the wire into the port on the BioModulator®. You can cause damage to your BioModulator® if it is knocked or bumped when plugged in. It is very important to remove the plug when not in use.

2. Turn on your BioModulator® (Pro or Plus).

3. Set the mode.

For BioModulator® Plus:

• TEN-8 for pain and inflammation related to muscle, bone, ligament, and tendons.

• INFINITY for all other issues related to organs and general health.

• INFINITY for eye treatment.

For BioModulator® Pro:

• TEN-8 for pain and inflammation related to muscle, bone, ligament, and tendons.

• INFINITY for all other issues related to organs and general health. • VA-STEP for eye treatment.

4. Adjust the power by pressing the + and – buttons. Since there is no skin contact you may increase the power as high as you want when using it on the body. When using it on the eyes set the power as is indicated in the eye treatment section (reference Quick Start Guide)

5. Point the BioTransducer at the area of concern, holding it between 1⁄2 an inch to 3 inches away from the body.

6. As a general guideline, therapy times are flexible just as they are when using the BioModulator alone.

For example:

a) 5 – 20 minutes for minor issues and for general use.

b) As long as needed for more serious conditions.

Tip: Therapy can continue for several hours when you mount the Senergy BioTransducer CrystalWave® III to a mic stand and position it on the area of concern.

What is the Daily Practice?

NOTE: You must have a BioModulator® device to complete this daily practice.

This daily practice will help balance and prepare your body so it can properly receive and use the voltage provided by your BioModulator® device for healing.

Click Here to read & download the full PDF on the Daily Practice

BioTransducer CrystalWave® III Technology