Some users experience a subtle tingle or sensation of warmth from the BioTransducer. Most people don’t feel any sensations when using the BioTransducer. You may feel initial apprehension about providing therapy to yourself or others. When you carefully follow the instructions and directions, there’s no need to be concerned. The devices and therapy steps were created with the knowledge that application will be general and does not have to be precisely aligned with any given point of the body. Even if you are providing the therapy to a different area than intended, it is not harmful and, in most cases, will still benefit you.

INSTRUCTIONS FOR USE

1. Connect the BioTransducer to the Tennant BioModulator with the connection wire. Use care when plugging the wire into the port on the BioModulator. You can cause damage to your BioModulator if it is knocked or bumped when plugged in. It is very important to remove the plug when not in use.

2. Turn on your BioModulator (Pro or Plus).

3. Set the mode.

For BioModulator Plus:

• TEN-8 for pain and inflammation related to muscle, bone, ligament, and tendons.

• INFINITY for all other issues related to organs and general health.

• INFINITY for eye treatment.

For BioModulator Pro:

• TEN-8 for pain and inflammation related to muscle, bone, ligament, and tendons.

• INFINITY for all other issues related to organs and general health. • VA-STEP for eye treatment.

4. Adjust the power by pressing the + and – buttons. Since there is no skin contact you may increase the power as high as you want when using it on the body. When using it on the eyes set the power as is indicated in the eye treatment section (reference Quick Start Guide)

5. Point the BioTransducer at the area of concern, holding it between 1⁄2 an inch to 3 inches away from the body.

6. As a general guideline, therapy times are flexible just as they are when using the BioModulator alone.

For example:

a) 5 – 20 minutes for minor issues and for general use.

b) As long as needed for more serious conditions.

Tip: Therapy can continue for several hours when you mount the BioTransducer to a mic stand and position it on the area of concern.

NOTE: You must have a BioModulator device to complete this protocol.

This daily protocol will help balance and prepare your body so it can properly receive and use the voltage provided by your BioModulator device for healing. This is accomplished by waking up and “activating” your organ systems, resetting your polarity so electrons flow correctly, balancing your autonomic nervous system, and recharging your whole body.

Click Here to read & download the full PDF on the Daily Protocol

Click Here to watch the Daily Protocol How-To Video

You can download this detailed instructional guide on how to care for and use your device to its fullest potential.

Click Here for the BioTransducer Crystal Wave QUICK START GUIDE